A.T. HOTBOX-Dirt Warrior Accessories

Description

A.T. HOTBOX by Dirt Specialties Dimensions:
14 5/8″L x 8 1/2″W x 8 1/2″H

Weight:
less than 13 lbs.

General Installation Instructions for the A.T. HOTBOX by Dirt Specialties

1 – Determine your mounting location for the A.T. Hotbox by Dirt Specialties

2 – Locate bypass line on motor (Fig 2) **If unsure, contact dealer to inquire about your model’s make and location of bypass line**

3 – Determine where to route hose to box, drill for hose ¾” – 1” hole

4 – Take two (2) needle nose vise grips, pinch off and cut bypass hose in half, approximately centered or best spot to go up through the bed to the predetermined mount location **Some older models will require a bit more intricate work – see website video for better instruction assistance**

5 – Install two (2) 3/8” couplers supplied in Install Kit and crimp on bypass line with oetiker clamps or stainless steel hose clamps

6 – Clamp on 3/8” hose, run up the holes drilled in bed to box mounting location

7 – Cut hose to desired length and fill with antifreeze compatible to your unit

8 – Unclamp vise grips – you now should have full lines to motor with no air

9 – Take supplied 4” length of clear hose, put on left side outlet of the A.T. Hotbox as you face it. With small funnel fill the A.T. Hotbox line with antifreeze (this should take approximately 14 ounces)

10 – Connect hose to the A.T. Hotbox and clamp. Check hoses to make sure not hitting exhaust or rubbing on anything. Zip tie as needed to prevent any potential rubbing

11 – Start unit and inspect for leaks. Allow to idle as to get to running temperature (usually approximately 180*), blip throttle a few times to assist any air bubbles that may have gotten caught in line while filling